Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Owens Corning Kitchen Remodeling: The Woodland Hills Owner’s Guide
A full Owens Corning kitchen remodel in Woodland Hills typically runs $14,000 to $45,000 installed, and the honest answer on timing is that this is not a same-day job. A kitchen remodel is a multi-week project: demolition, rough-in, drywall, flooring, cabinetry, counters, and finish work. Where Owens Corning comes in is the part of that remodel people rarely think about until a wall comes open: insulation, moisture control, and the building envelope materials that keep a new kitchen from rotting, swelling, or costing you money in lost cooling all summer long.
Most Woodland Hills homeowners don’t call us because their Owens Corning product “failed” in the way a spring snaps. They call because a previous remodel cut corners behind the walls, and now there’s a soft spot under the sink cabinet, a warm wall that faces the afternoon sun, or noise bleeding through from the garage. The fix lives inside the wall cavity, not on the surface.
Key Takeaways:
- Full Owens Corning kitchen remodels in Woodland Hills run $14,000 – $45,000 installed, depending on materials and scope.
- Mason Remodeling Co Woodland Hills is an independent contractor, not affiliated with Owens Corning.
- We use Owens Corning insulation and building envelope products inside our kitchen remodels, and we stock the most common board and batt sizes on our vehicles.
- Homeowners in Woodland Hills feel the difference most in July and August, when properly insulated kitchen walls can cut cooling demand in a room full of heat-generating appliances.
Which Owens Corning Models This Applies To
Owens Corning doesn’t make a kitchen remodel “kit.” What they make are the building materials that determine whether a remodel lasts ten years or forty. Their fiberglass batt insulation comes in the familiar pink rolls, but the product line that matters most for kitchens is their FOAMULAR rigid foam board (the pink board), available in thicknesses from 1/2 inch up to 2 inches, with R-values from R-2.5 to R-10 depending on the board. We also use their PINK Next Gen fiberglass batts with R-values from R-11 to R-38.
A compatibility detail most homeowners never hear: not every cavity takes the same product. A 2×4 wall between a kitchen and a garage gets R-13 or R-15 batts. A 2×6 exterior wall behind your stove run gets R-19 to R-21. And the band joist where the kitchen floor meets the foundation is where we most often see builders skip Owens Corning rigid foam, leaving a thermal gap that lets heat crawl under the cabinets. If your kitchen was built before 1980 in Woodland Hills, there’s a good chance the wall cavities behind the tile and cabinets have no insulation at all, or something that has settled to half its original R-value.
We stock OEM Owens Corning products and carry quality aftermarket equivalents when the spec calls for it. For insulation, there is no good reason to substitute: Owens Corning is the standard we trust, and the price difference is small enough that it doesn’t make sense to gamble on an off-brand batt that labels itself R-15 but installs like R-11 because it’s cut poorly.
Styles & brands we work with
Signs Your Owens Corning Kitchen Remodeling Is Failing
Most of these signs are things you can spot in a weekend walkthrough. None of them require a tool.
- Condensation on the inside of the kitchen window, especially in winter mornings. This tells you warm, moist kitchen air is meeting a cold glass surface. It often means your wall insulation was compromised or never installed to spec. Owens Corning batts between the window and the outside wall should be holding that cold at bay.
- Draft you can feel around outlets and light switches on exterior walls. This is a classic sign the wall cavity behind the drywall is under-insulated. The outlet box creates a gap in the insulation path, and West Valley winds from the canyons push right through it.
- Mold or a musty smell under the sink cabinet, near the dishwasher, or behind the trash pull-out. Water from the sink or plumbing has found its way behind the cabinet back panel. Once moisture gets into uninsulated or poorly insulated wall cavities, it sits there. Owens Corning batts with their moisture-resistant facing help, but only if the waterproofing around the plumbing was done right in the first place.
- Kitchen feels 8-10 degrees warmer than the rest of the house in summer, even with the AC running. Kitchens have refrigerators, ovens, and dishwashers all generating heat. If the exterior wall behind your range isn’t insulated to current specs, that heat never leaves the room. We see this constantly in the older ranch houses throughout Woodland Hills.
- Drywall cracking at the corner above the kitchen window or door opening. This is often a settling issue, not an insulation issue, but it’s how homeowners first notice something is off behind the wall. If we’re already opening that wall for insulation, we check the structural framing while we’re in there.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s what a Woodland Hills homeowner should expect to pay for a kitchen remodel that includes proper Owens Corning insulation and building envelope work, not just new cabinets and countertops.
| Scope | Installed Price Range |
|---|---|
| Full kitchen remodel with Owens Corning insulation rework | $14,000 – $45,000 |
| Small kitchen remodel (galley or compact layout) | $9,000 – $20,000 |
| Cabinet installation (supplied and installed) | $4,000 – $13,000 |
| Countertop installation (Cambria, Silestone, or Caesarstone) | $2,000 – $6,500 |
| Backsplash installation | $800 – $2,500 |
| Kitchen island installation | $3,000 – $10,000 |
What pushes a project toward the top of that range? Taking walls down to the studs, re-insulating every cavity, moving plumbing, or correcting water damage from a previous owner’s poor tile work. What pushes it lower? Keeping the existing footprint, re-insulating only the exterior wall, and choosing stock cabinetry instead of custom. Every estimate from Mason Remodeling Co Woodland Hills is a written, line-item price before any work starts. If the price changes, you’ll know why before it does. Every job is covered by our 365-Day Done Right Promise: if the work isn’t right within a year of completion, we fix it at no cost to you.
DIY or Call Us?
There are a few things you can check safely on your own. Pull an outlet cover off an exterior kitchen wall (after turning off the breaker) and look for insulation behind the box. Put your hand near the wall behind your refrigerator on a hot afternoon and compare it to an interior wall. Look under the sink cabinet for signs of past leaks. None of that requires a professional.
What you should not do is start cutting drywall open to inspect insulation yourself. Fiberglass batts are not dangerous like a garage-door spring, but a wrong cut into a wall can hit electrical wiring, plumbing, or a stud you need for load support. When we open a Woodland Hills kitchen wall, the first thing we’re looking for is the existing Romex and copper, not the insulation. And once the wall is open, the real skill is air-sealing the cavity correctly before the new Owens Corning batts go in. Batts stuffed around an unsealed outlet box are half as effective as they should be. That detail, done wrong, is the difference between a kitchen that holds temperature and one that doesn’t. If you want us to take a look, call (831) 290-6866. Isaac Pruett will tell you what it takes and what it costs, then we get to work.
FAQs
When installed dry and sealed from moisture, Owens Corning fiberglass batts and FOAMULAR rigid board will perform for the life of the home. In Woodland Hills, the biggest threats are roof leaks above the kitchen, plumbing leaks inside the wall, and termite activity, which can compress or displace insulation. An inspection every few years when you repaint is enough.
Sometimes. If the cavity is dry and the batt has simply slipped or settled at the top of a wall, we can re-seat it and re-seal the vapor barrier without replacing the whole wall. If the insulation got wet from a leak, it comes out. Wet fiberglass loses its R-value, holds moisture against the framing, and becomes a mold site, so replacement is the only fix. Call (831) 290-6866 and we’ll give you an honest read on what your walls need.
Most full kitchen remodels in Woodland Hills run four to eight weeks from demolition to final walkthrough. Insulation work itself is usually a one-day job inside that timeline, but it has to happen at the right point: after rough-in and electrical inspection, before drywall goes up. Rushing that sequence causes problems you’ll feel for years.
We keep the most common Owens Corning PINK Next Gen batts (R-13, R-15, R-19) and FOAMULAR boards (1/2-inch and 1-inch) on our vehicles, along with KraftMaid cabinetry spec sheets, Cambria and Silestone countertop samples, and the Schluter strips we use for tile edging. If your project needs something outside those sizes, we order it from our local supplier and typically have it on site within a few business days.
Written by Isaac Pruett, Owner, Mason Remodeling Co – Woodland Hills, CA at Mason Remodeling Co Woodland Hills, serving Woodland Hills and nearby areas.
