Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Techo-Bloc Fence Installation: The Woodland Hills Owner’s Guide
Techo-Bloc fence installation in Woodland Hills typically runs $3,500 to $9,000 installed, depending on linear footage, terrain, and whether we’re replacing failed panels or building from scratch. We stock Techo-Bloc fence panels and posts at our Woodland Hills yard, so most jobs get quoted within a day and scheduled within the week. Where owners usually find us: a post has cracked at the base after a wet winter, a panel has shifted out of true and now rattles against its neighbor, or the fence looked fine in June and now leans a good four inches toward the property line because the base course settled. If that sounds familiar, the rest of this page tells you what you’re dealing with, what it costs, and how we handle it.
Key Takeaways
- Techo-Bloc fence installation in Woodland Hills typically costs $3,500 to $9,000 installed.
- We’re an independent contractor, not a Techo-Bloc dealer, which means we match panel sizes and colors without upselling proprietary add-ons.
- Most failures trace back to two causes: base settling or post base freeze-thaw cracking, both common in the Valley’s clay-heavy soil.
- Written price before work starts, per our standard on every job. You know the number before we touch a single block.
Which Techo-Bloc Models This Applies To
Techo-Bloc’s fence and screen wall lines span a few series that look similar from a distance but don’t interchange cleanly up close. The ones we install most around Woodland Hills are the Graphix wall system and the Evolve screen block line, both modular dry-stack or adhesive-set systems built on a concrete base course. Here’s the compatibility gotcha most homeowners hit: panel dimensions are nominal, not true. A Graphix panel listed as 24 inches wide measures closer to 23-5/8 inches to allow for joint spacing, and Evolve blocks step down in half-inch increments, so grabbing a “close enough” panel from a different series leaves a gap that collects dirt and wobbles in wind. We measure every panel and post on site before ordering anything.
On OEM versus aftermarket: Techo-Bloc’s color blends are lot-specific. Two batches of the same color code purchased six months apart can read visibly different once the sun hits them, especially in the beige and grey ranges that dominate Woodland Hills backyards. We match by lot number when we can, and when we can’t, we’ll tell you before you pay a cent. We also stock Techo-Bloc-compatible caps and adhesives on the truck, so a partial repair doesn’t turn into a week-long wait for a small part.
Styles & brands we work with
Signs Your Techo-Bloc Fence Installation Is Failing
- Post lean at the base, not the middle. That means the concrete footing has cracked or the base course blocks have shifted, not that the post itself failed. Fixing the post without fixing the base means the lean comes back within a season.
- Panels rattling against each other in wind. The joint adhesive or dry-stack connector has let go, usually after repeated expansion and contraction through Valley heat cycles. A panel that rattles now will crack at the edge within a couple of summers.
- Horizontal hairline cracks running through panel faces. This is freeze-thaw damage, and in Woodland Hills it shows up more on shaded north-facing fence lines where moisture sits in the block longer than it should.
- Caps popping off or sitting proud. The adhesive underneath has failed or the cap was set without enough coverage. Water gets under the cap, works down into the panel core, and starts the cycle that ends with a split block.
- Visible gap between the bottom course and the soil line. That gap means settling. In Woodland Hills, where much of the ground is expansive clay that shrinks and swells with rain, a base that was never properly prepared will drop and drag the bottom course with it.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For a Techo-Bloc fence installation in Woodland Hills, you’re looking at $3,500 to $9,000 installed for a typical residential run. At the lower end, that’s a repair section, maybe twenty to thirty linear feet with a few panels and caps replaced and the base stabilized. At the upper end, it’s a full perimeter, new footing, base course re-leveled, and a fresh installation from grade up. What drives the spread:
- Base work. If the original base was poured too thin or set directly on uncompacted soil, we’re rebuilding it before any block goes up. That’s the single biggest variable on Techo-Bloc fence jobs in this area.
- Access and terrain. A fence on a slope or behind mature landscaping takes longer to prep and stage.
- Panel count and series. Graphix and Evolve blocks are not interchangeable, and the per-panel cost differs between the two lines.
Every quote includes parts, labor, haul-away of the failed section, and our 365-Day Done Right Promise: if anything we installed isn’t right within a year, we come back and make it right at no cost. You get that in writing, same as the price.
DIY or Call Us?
What an owner can safely check: whether the lean changes after rain, whether caps lift by hand, whether a section of fence has visibly separated from the one next to it. Those observations help us quote faster over the phone. What we don’t recommend: pulling a failed panel out of a load-bearing run. Techo-Bloc fence systems are designed so that each section contributes to the stability of the ones beside it. Removing a middle panel without bracing the adjacent sections can drop the whole line, and a falling landscape block weighs more than most people expect. We handle this part for a reason.
If you’re in Woodland Hills and you’ve got a Techo-Bloc fence that’s leaning, cracking, or separating, call (831) 290-6866 and tell us what you’re seeing. We’ll get a name and a face to your door, put a written price in your hand, and the fence goes back together the way it should have been built the first time.
FAQs
With a properly prepared base and quality adhesive, a Techo-Bloc fence should last 25 to 30 years before any meaningful structural work is needed in this climate. The weak point in Woodland Hills is almost never the block; it’s the base preparation, which is why we spend more time on the footing than most installers do. Call (831) 290-6866 for a quote on yours.
Small hairline cracks can sometimes be stabilized with structural adhesive and a color-matched fill, but any panel with a crack wider than a few millimeters or visible spalling along the edge should be swapped out. The repaired panel will always be the first thing to fail again. We’ll give you an honest read when we look at it.
A typical repair runs one to two days, and a full fence replacement in Woodland Hills usually takes three to five days depending on the length of the run and what we find in the base. We give you the timeline in the written quote so you know what to plan around.
We keep Techo-Bloc-compatible panels, caps, adhesives, and base course material on hand at our Woodland Hills location, and we order specific colors and batches directly as needed. You don’t have to track down parts or coordinate with a supplier, that’s part of what you’re paying us for.
Written by Isaac Pruett, Owner, Mason Remodeling Co – Woodland Hills, CA at Mason Remodeling Co Woodland Hills, serving Woodland Hills and nearby areas.
