Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Barrette Kitchen Remodeling: The Woodland Hills Owner’s Guide
If you have Barrette cabinetry or trim in your Woodland Hills kitchen and a door hinge has snapped, a drawer slide has worn out, or a cabinet frame has started pulling away from the wall, we stock the replacement hardware and can typically install it the same week. A full Barrette-compatible kitchen remodeling project in Woodland Hills runs $14,000 – $45,000 installed, while targeted part replacements like hinges, slides, and trim usually land between $150 and $900 including labor. Most owners discover the failure the way you just did: a drawer that suddenly drags, a door that hangs crooked, or a soft-close mechanism that stopped doing its one job.
We’re an independent remodeling contractor in Woodland Hills, not a Barrette dealer or affiliate. That means we’re free to tell you honestly whether a part is worth replacing or whether the cabinet itself has reached the end of its useful life. Isaac Pruett, our owner, grew up in Los Angeles and has spent years working on kitchens across the Valley, including plenty near Warner Center. He’s seen Barrette cabinets hold up well for decades, and he’s seen the specific failure points that show up first in Southern California’s dry heat and temperature swings.
Which Barrette Models This Applies To
Barrette has manufactured cabinet lines for builder-grade kitchens, semi-custom projects, and aftermarket refacing jobs over the years. The compatibility question matters more than most homeowners expect, because the hinge boring pattern, drawer slide length, and face-frame dimensions vary between Barrette’s stock lines and their later soft-close series. If you have a label inside a drawer or on the back of a cabinet door, that tells us most of what we need. No label? We measure the hinge cup diameter, the overlay, and the slide extension, then match from there.
Here’s a gotcha we run into regularly in Woodland Hills homes built in the 1990s and early 2000s: Barrette cabinets from that era often use a 35mm hinge cup that’s compatible with most Blum and Salice knock-in hinges, but the screw pattern on the face frame side is offset by 2mm from the modern standard. That means a generic hinge from the big-box store will look right in the package and then bind when you close the door. We carry OEM Barrette hardware where it’s still available, and quality aftermarket equivalents (Blum, Grass, and Salice) where the original part has been discontinued. We’ll tell you which one you’re getting and why.
Key Takeaways
- Barrette kitchen remodeling in Woodland Hills: $14,000 – $45,000 for a full project; $150 – $900 for targeted part replacement.
- We stock common Barrette hinges, slides, and trim in our van, and can order discontinued parts with a 3-5 business day lead time.
- Every crew member is verified by name and photo before they arrive, under The Threshold Standard.
- You get a written price before any work starts and a written guarantee covering 365 days from completion.
Styles & brands we work with
Signs Your Barrette Kitchen Remodeling Is Failing
- A drawer slides halfway and then sticks. This usually means the nylon roller inside the slide has flattened on one side, or the ball bearing track has picked up years of grease and flour dust. Barrette’s older epoxy-coated slides were good for maybe 15 years of daily use in a busy Woodland Hills kitchen before the coating wears through.
- A cabinet door won’t stay closed, or sags when it’s open. The hinge spring has failed, or the mounting screws have stripped out of the face frame. We see the stripped-screw version constantly in homes where the original installers used a 5/8″ screw where a 7/8″ screw belonged.
- Soft-close stops working on one door but not others. The damper piston inside the hinge has leaked its internal fluid. You can’t refill it. This is a replace-the-hinge job, not a repair, and it’s a $35 – $80 part depending on the Barrette series.
- The cabinet box itself pulls away from the wall or a corner joint opens up. This is the one that matters. It’s rarely the cabinet’s fault – usually it’s a moisture event (a slow sink leak, a dishwasher venting problem) that swelled the particleboard. In Woodland Hills’ dry climate, the damage often goes unnoticed for years because the swelling happens slowly, then the cabinetry dries out and the screws lose their grip.
- Laminate or thermofoil facing peels at the edges near the cooktop or dishwasher. Heat and steam cycling breaks the adhesive bond. Once peeling starts, it doesn’t stop. Refacing that single door or drawer front is often $120 – $300, which beats replacing the entire run.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For part replacement in Woodland Hills, expect $150 – $900 installed depending on what failed. A single hinge swap runs $150 – $250 including the part, the trip, and the labor. A full set of soft-close hinges for a 36-inch door pair runs $400 – $700. Drawer slides for six drawers typically land around $500 – $900. If your Barrette cabinets need more than parts – resurfacing, structural repair, or a full replacement – a complete kitchen remodel in Woodland Hills runs $14,000 – $45,000, and a smaller kitchen typically falls between $9,000 and $20,000. You’ll see a written line-item price before any work begins, not a verbal range that grows later. The work is covered by our 365-Day Done Right Promise: if it’s not right within a year of completion, we make it right at no cost.
DIY or Call Us?
Cabinet hardware is low-risk to inspect yourself. You can open a drawer, look at the slide, and tell us what you see. You can wiggle a door and confirm the hinge is loose. What we’d steer you away from is the YouTube repair rabbit hole on anything involving cabinet structure – if a corner joint has separated or the box is pulling from the wall, the fix usually involves clamping, shimming, and sometimes a face-frame screw that has to bite into a stud behind drywall that’s no longer flat. That’s where homeowners burn a Saturday and end up with a door that’s worse than when they started. High-tension hardware inside soft-close mechanisms can also pinch fingers or snap back if released wrong. If you’re unsure, call (831) 290-6866 and describe what you’re seeing. We’ll tell you over the phone whether it’s worth a service visit. No charge for the conversation.
FAQs
Barrette cabinet boxes and face frames typically last 20 – 30 years in Woodland Hills if they stay dry, though hinges and slides usually need replacing around the 10 – 15 year mark. If your cabinets are pushing 25 years old and multiple parts are failing at once, it’s often more cost-effective to reprice a full remodel than to keep replacing hardware piecemeal. Call (831) 290-6866 for an exact quote on either path – estimates are free.
The hinge itself needs replacing – the internal spring or damper can’t be rebuilt. What we can sometimes repair is the cabinet door or face frame where the hinge mounts, if the screw holes have stripped. Call (831) 290-6866 and we’ll tell you which situation you have.
Most hardware swaps – hinges, slides, soft-close mechanisms – take 60 to 90 minutes for a full kitchen’s worth, assuming the parts are in the van. If we need to order a discontinued Barrette part, allow 3-5 business days. We’ll give you a written time window and the technician’s name and photo before the visit.
We stock common Barrette hinges, drawer slides, and mounting hardware in our Woodland Hills service vehicle, and we order OEM or equivalent parts for less common series as needed. You don’t need to buy anything ahead of time. If you already have a part you bought online, we’ll install it at our standard labor rate, but we can’t warranty a part we didn’t supply.
If your Barrette cabinets are failing and you want a straight answer on whether to repair or remodel, call (831) 290-6866. Tell me what you need done. I’ll tell you what it takes and what it costs. Then we get to work.
Written by Isaac Pruett, Owner, Mason Remodeling Co – Woodland Hills, CA at Mason Remodeling Co Woodland Hills, serving Woodland Hills and nearby areas.
