Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
CWS Kitchen Remodeling: The Woodland Hills Owner’s Guide
A full CWS kitchen remodeling project in Woodland Hills typically runs $14,000 to $45,000 installed, depending on cabinet line, countertop material, and whether you’re moving plumbing or electrical. We stock and install CWS-compatible components for kitchens across Woodland Hills, and we can usually get your project started within two to three weeks of the written estimate. Most owners realize what they’re dealing with when a cabinet face delaminates from years of Valley heat, a drawer slide starts grinding, or a countertop seam pulls apart after too many dry seasons.
Which CWS Models This Applies To
If you’ve got CWS cabinetry in your Woodland Hills kitchen, you’re working with one of their framed or frameless box lines. The compatibility issue that trips up most homeowners is the hinge boring pattern: CWS frameless boxes use a 35mm cup boring with a specific overlay, so the hinges aren’t interchangeable with standard face-frame hardware from the big box stores. Check the inside of a drawer box or the back of a cabinet door for a CWS stamp or label with the series number, then measure the door overlay before you buy replacement hinges or slides. For most CWS-era kitchens in Woodland Hills homes built between 1995 and 2015, we recommend upgrading to Blum soft-close hardware rather than chasing discontinued OEM parts that cost more and last about as long in our climate. OEM CWS parts are fine if you want an exact match, but quality aftermarket drawer slides and hinges have caught up in fit and finish, and they’re what we keep on the truck for most service calls.
Styles & brands we work with
Signs Your CWS Kitchen Remodeling Is Failing
- Door or drawer no longer closes flush: The hinge plates lose their grip in the particleboard over time, especially when Woodland Hills summer heat cycles cause the cabinet box to expand and contract. You’ll see a 1/8-inch gap at the top corner that wasn’t there when the kitchen went in.
- Sagging drawer boxes: Original CWS drawers from that era often used epoxy-coated metal slides. Once the ball bearings wear flat, the drawer drops and scrapes the cabinet face below it.
- Peeling cabinet door edges: Thermofoil doors peel at the bottom edge first, and the Valley’s dry heat doesn’t do them any favors. Once the seal breaks, the door will keep peeling no matter what you do.
- Separation at the countertop seam: Natural stone and quartz seams can spread when the base cabinets settle or the subfloor shifts. You’ll feel a lip with your thumbnail running across the seam line.
- Stripped hinge screws spinning in place: The original screw holes wallow out in the particleboard. If you can spin a screw with your fingers and it never tightens, the hinge isn’t holding the door weight anymore.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
In Woodland Hills, a kitchen remodel with CWS-compatible cabinetry and new countertops lands in the $14,000 to $45,000 range. A smaller galley kitchen with new doors, hardware, and laminate counters stays closer to $14,000; a full tear-out with custom cabinet boxes, Cambria or Silestone tops, an island, and a new backsplash runs toward the top of that range. What drives the number most is whether we’re reusing the existing cabinet footprint or moving walls, plumbing, and electrical, because that’s where permit time and rough-in labor add up. Every quote we write includes the parts, the labor, the haul-away, and the finish work, with no change orders added mid-job unless you choose to expand the scope. That price is in writing before we start, and our work is covered by the 365-Day Done Right Promise: if something isn’t right within a year of completion, we fix it at no cost.
DIY or Call Us?
Replacing a stripped hinge screw with a longer one is something most Woodland Hills homeowners can handle in ten minutes, and we’ll tell you that straight. What goes wrong in a hurry is when someone tries to re-hang a full-height pantry door or manhandle a quartz slab off a base cabinet without the right lift points. Quartz and granite slabs weigh 18 to 25 pounds per square foot, and a dropped corner will crack the stone, the floor, or a foot. If you’re dealing with anything beyond a hinge or a drawer slide, call us at (831) 290-6866 and we’ll look at it. Either way, we’ll give you a written number before you commit to anything.
FAQs
With proper care, CWS cabinetry lasts 15 to 25 years in Woodland Hills homes, though doors and drawer faces in direct afternoon sun may show edge wear by year eight. The box frames usually outlast the doors and hardware, which is why so many homeowners choose to reface rather than fully replace. Call (831) 290-6866 and we’ll tell you whether your boxes are worth keeping.
Thermofoil peeling can’t be reliably repaired, and any fix will look temporary within a season or two. Solid wood or painted doors can be sanded, filled, and refinished, but the cost of refinishing multiple doors often overlaps with the cost of new ones. Call (831) 290-6866 and we’ll give you an honest read on which doors are worth saving.
Most full CWS kitchen remodels in Woodland Hills take four to eight weeks from demo to final walk-through, depending on permitting, plumbing location, and countertop templating lead times. Cabinet-only or refacing projects usually wrap in one to two weeks. Before we start, we’ll give you a written schedule so you know what to expect each week.
We keep the most common CWS-compatible hinge plates, soft-close drawer slides, and door bumpers on the truck for same-visit repairs, along with touch-up kits for common Woodland Hills kitchen finishes. If we need a specific OEM CWS part, we’ll source it and let you know the lead time before we schedule. Call (831) 290-6866 and ask us; chances are we’ll have it on hand. Beyond CWS, we also work with KraftMaid, Cambria, and Silestone components for the broader Woodland Hills market.
Written by Isaac Pruett, Owner, Mason Remodeling Co – Woodland Hills, CA at Mason Remodeling Co Woodland Hills, serving Woodland Hills and nearby areas.
